System Compressor Parameters - Roland RD-2000 Parameter Manual

System Compressor Parameters

This is a stereo compressor (limiter) that is applied to the final output.
With separate settings for the high-frequency range, midrange, and low-frequency range, this reduces inconsistencies in volume levels by
compressing the sound when the volume exceeds a preset volume level.
Parameter Value
Compressor
OFF, ON
Switch
When you change this parameter, the
Compressor parameters will be automatically
adjusted to the optimal values.
You can make the settings easily by first setting
the Compressor Type and then changing only the
necessary parameters.
HARD COMP
Type
SOFT COMP
LOW BOOST
MID BOOST
HI BOOST
USER
40, 50, 63, 80, 100,
Split Freq 125, 160, 200, 250,
Low
315, 400, 500, 630,
800 [Hz]
400, 500, 630, 800,
1000, 1250, 1600,
Split Freq
2000, 2500, 3150,
High
4000, 5000, 6300,
8000 [Hz]
Common to Low, Mid, and High
Parameter Value
0–24 [dB]
Level
(1 dB Step)
Attack Time 0–100
Release Time 0–100
-60–0 [dB]
Threshold
(1 dB Step)
1:1.0, 1:1.1, 1:1.2,
1:1.4, 1:1.6, 1:1.8,
Ratio 1:2.0, 1:2.5, 1:3.2,
1:4.0, 1:5.6, 1:8.0,
1:16, 1:INF
Explanation
Turns the compressor on/off .
Applies strong compression.
Applies mild compression.
Boosts the low end.
Boosts the midrange.
Boosts the high end.
The saved settings are
written.
Sets the frequency
separating the low-frequency
range (LOW) and midrange
(MID).
Sets the frequency separating
the high-frequency range
(HIGH) and midrange (MID).
Explanation
Output Level
Sets the time it takes until the
level is compressed after the
input exceeds the Threshold.
Sets the time it takes for the
compression to be released
after the input falls below the
Threshold.
Sets the level at which
compression begins.
Compression Ratio
69