Table of Contents
Advertisement
Detailed Settings for Various Functions (Utility Screen)
How to Make Settings
1.
From the Tone screen, press the [Function] button to turn
Function on.
The [Function] button will light when the function is on.
2.
Press the [F4 (UTILITY)] button to access the Utility
screen.
3.
Use the [F3 (▲)] / [F4 (▼)] buttons or the [Value] dial to
select a group.
fig.Util02.eps
4.
Press the [Enter] button or the [F1 (ENTER)] button to see
the parameters in that group.
5.
Use the [F3 (▲)] / [F4 (▼)] buttons to select a parameter
within the group.
fig.Util03.eps
6.
Turn the [Value] dial to adjust the value.
You can press the [F2 (RESET)] button to return to the initial value.
Simply changing a value does not cause the change to be
memorized. You must execute the Write operation to store
your change in the appropriate memory location for that
parameter. Refer to "Parameters That Can Be Set" (p. 57) for
the memory locations and procedure for each parameter.
7.
Press the [Exit] button to return to the previous screen.
56
Saving the System Parameters
With the Utility screen "1. System" shown, press the [Write] button;
the parameters will be saved to system memory.
You cannot save just an individual parameter by itself. When
you save the System parameters, all the parameters you
modified will be saved in a single operation.
1.
From the Tone screen, press the [Function] button to turn
Function on.
The [Function] button will light when the function is on.
2.
Press the [F4 (UTILITY)] button to access the Utility
screen.
3.
Use the [F3 (▲)] or [F4 (▼)] buttons to select "1. System."
fig.Util02.eps
4.
Press the [Enter] button or the [F1 (ENTER)] button to
access the system setting screen.
5.
Press the [Write] button.
A confirmation message will appear.
If you decide to cancel without saving, press the [F1 (CANCEL)]
button.
6.
To save the system parameter, press the [F4 (OK)] button.
All of the System parameters you edited will be saved to System
memory.
Advertisement
Table of Contents
