Od/Ds 0 Awah; Enhancer 0 Chorus - Roland RD-2000 Parameter Manual

Parameter Value
TWah Polarity DOWN, UP
TWah Sens # 0–127
TWah Manual
0–127
#
TWah Peak # 0–127
TWah D100:0W–
Balance # D0:100W
Low Gain -15–+15 [dB]
High Gain -15–+15 [dB]
Level 0–127

56: OD/DS 0 AWAH

L in
Overdrive/ Amp
Distortion Simulator
R in
Parameter Value
Switch
OFF, ON
DRIVE,
TONE,
Depth Knob
AUTOWAH
MANUAL,
AUTOWAH PEAK,
AUTOWAH RATE,
AUTOWAH DEPTH,
Rate Knob
AUTOWAH
BALANCE
OFF,
DRIVE,
TONE,
AUTOWAH
Feedback MANUAL,
Knob AUTOWAH PEAK,
AUTOWAH RATE,
AUTOWAH DEPTH,
AUTOWAH
BALANCE
Drive Switch OFF, ON
OVERDRIVE,
Drive Type
DISTORTION
Drive # 0–127
Tone # 0–127
Amp Switch OFF, ON
Explanation
Direction in which the filter
will move
UP: Move toward a higher
frequency
DOWN:
Move toward a lower
frequency
Sensitivity with which the
filter is modified
Basic frequency at which the
wah effect is applied
Width of the frequency
region at which the wah
effect is applied
Increasing this value will
make the frequency region
narrower.
Volume balance of the sound
that passes through the wah
(W) and the direct sound (D)
Gain of the low range
Gain of the high range
Output Level
L out
Auto 2-Band
Wah EQ
R out
Explanation
Turns the effect on/off.
Specifies the parameter
that is controlled by the
MODULATION FX [DEPTH]
knob.
Specifies the parameter
that is controlled by the
MODULATION FX [RATE]
knob.
Specifies the parameter
that is controlled by the
MODULATION FX [FEEDBACK]
knob.
Overdrive/distortion on/off
Type of distortion
Degree of distortion
Also changes the volume.
Sound quality of the
Overdrive effect
Turns the Amp Simulator on/
off.
Parameter Value
SMALL,
BUILT-IN,
Amp Type
2-STACK,
3-STACK
AutoWah
OFF, ON
Switch
AutoWah
LPF, BPF
Filter Type
AutoWah
0–127
Manual #
AutoWah
0–127
Peak #
AutoWah
Rate OFF, ON
(sync sw)
AutoWah
0.05–10.00
Rate (Hz) #/
AutoWah
note (p. 60)
Rate (note) #
AutoWah
0–127
Depth #
AutoWah D100:0W–
Balance # D0:100W
Low Gain
-15–+15 [dB]
High Gain -15–+15 [dB]
Level 0–127

57: ENHANCER 0 CHORUS

L in
Enhancer
Mix
R in
Enhancer
Mix
Parameter Value
Switch OFF, ON
Depth Knob
ENHANCER SENS,
ENHANCER MIX,
CHORUS RATE,
CHORUS
BALANCE
Rate Knob
Modulation FX Parameters
Explanation
Type of guitar amp
SMALL:
small amp
BUILT-IN:
single-unit type
amp
2-STACK:
large double stack
amp
3-STACK: large triple stack
amp
Wah on/off
Type of filter
LPF: Produces a wah effect in
a broad frequency range.
BPF:
Produces a wah effect in
a narrow frequency range.
Basic frequency at which the
wah effect is applied
Width of the frequency
region at which the wah
effect is applied
Increasing this value will
make the frequency region
narrower.
If this is ON, the modulation
is synchronized to the tempo
of the rhythm (owner's
manual: p. 24).
[Hz]
Rate at which the wah effect
is modulated
Depth at which the wah
effect is modulated
Volume balance of the sound
that passes through the wah
(W) and the direct sound (D)
Gain of the low range
Gain of the high range
Output Level
Balance D
Balance W
Chorus
Balance W
Balance D
Explanation
Turns the effect on/off.
Specifies the parameter
that is controlled by the
MODULATION FX [DEPTH]
knob.
Specifies the parameter
that is controlled by the
MODULATION FX [RATE]
knob.
L out
R out
57