Hazard Warning Lamp; Partial Operation Function; Adding Fuel In Time; Replacing The Bulb - Chery Tiggo Owner's Manual

Emergency

Hazard Warning Lamp

The hazard warning lamp is used only in case of
emergencies to warn vehicles behind and in the
opposite direction. If your vehicle breaks down or
is in imminent danger, press the hazard warning
lamp switch to turn on or off the lamp. When the
ignition switch is turned off, the hazard warning
lamp can still work.

Partial Operation Function

The control system of the engine of this vehicle
has the partial operation function, which enables
the system to continue running even if it is faulty.
However, the performance of the engine may
deteriorate at that time.
In case of system failure, please send
the vehicle immediately to Chery authorized
service station for inspection.

Adding Fuel in Time

If the fuel gauge indicates low fuel
level or the alarm lamp is on, add fuel as soon
as possible.
When the fuel has reached a too low level and the
low fuel level alarm lamp has been on for some
time, the engine will run unsteadily as an extra
warning. Please drive the vehicle to the nearest
gas station to add fuel.
Failure to add fuel in time will cause
the engine to stall on its own, leading to hard
start even damage to the engine. You shall
contact with Chery authorized service station
for help.
Using Fuel Gun Correctly in Filling
The fuel gun shall be inserted into the fuel
●
tank completely. Do not tilt it against the fuel
filler.
Emergency Procedure
● If an automatic fuel gun is used, once the gun
closes automatically, it indicates that the fuel
tank is filled up. In this case, do not attempt to
continue filling, or there will be no expansion
space in the fuel tank. Once the temperature
rises, the fuel tank will overflow.
After adding the fuel, make sure to tighten the
●
fuel tank cap.
● If spare canned fuel is carried on the vehicle,
make sure to observe relevant local laws and
regulations.
For safety reasons, it is advised not to carry spare
canned fuel on the vehicle lest the oil can be
damaged and the fuel overflows to cause fire.

Replacing the Bulb

Before replacing any lamp bulb, make sure to turn
off the lamp and turn off the ignition switch.
Don't hold the lamp bulb glass directly with fingers,
otherwise fingerprints left on it will volatilize due to
heat from the lighted lamp, deposit on the mirrors
and darken the reflector.
101