Replacing Lamp Bulb; Adjusting Headlamp Beam; Fuse And Relay - Chery A3 User Manual

Replacing Lamp Bulb

Before replacing any lamp bulb, make sure to turn
off the lamp and disconnect the ignition switch.
Unless in especially urgent situations, headlamp
bulbs shall not be replaced by the user, because
such lamp bulbs and relevant accessories need to
be removed before replacement. For example, the
washer reservoir needs to be removed if the right
headlamp bulb is to be replaced while the resonant
chamber be removed if the left headlamp bulb is to
be replaced, and then the bulbs are replaced from
behind the headlamps.
Don't hold the lamp bulb glass directly with fingers,
otherwise fingerprints left on it will volatilize due to
heat from the lighted lamp, deposit on the mirrors
and darken the reflector.
To replace a lamp bulb, make sure to use a bulb of
same type. Please check the specification of the
lamp bulb before installing it.
High Beam Lamp Bulb and Low Beam Lamp
Bulb
12V 55W, 12V 55W
Turn Lamp Bulb, Reverse Lamp Bulb and Rear
Fog Lamp Bulb
12V 21W
Stop Lamp Bulb
12V 18W
License Lamp Bulb, Position Lamp Bulb, Side
Turn Lamp Bulb, and High-Mounted Stop Lamp
Bulb
12V 5W
Stop Lamp Bulb and Position Lamp Bulb
12V 18W, 12V 5W
Front Fog Lamp Bulb
12V 55W
Parameters of Capacity and Specifications
Each time a headlamp bulb has been
replaced, the headlamp shall be corrected.
Chery authorized service station can provide
this service for you.

Adjusting Headlamp Beam

The proper adjustment of the headlamp beam
directly concerns the driving safety. Therefore, only
special instruments can be used to adjust the
beam. Please observe the law in this regard.

Fuse and Relay

Before the fuses and the relay are
replaced, the ignition switch and all the electrical
equipment shall be turned off.
56