Light Control; Headlamp Switch - Chery Tiggo Owner's Manual

Hide thumbs Also See for Tiggo:
Table of Contents

Advertisement

Light Control

Light Control
Please comply with relevant traffic laws when
using the lighting devices as follows.
When the vehicle is driven in rainy days, the glass
of window will be cooled rapidly and the
temperature around the glass inside the vehicle
will decrease fast, so the vapor contained in air will
be agglomerate to form water. And the water will
adhere to the inner side of window glass to form
dew. The reason for formation of dew on the inner
surface of headlamp glass lens is the same. In
other words, the amount of water contained in air
will increase with the rising of temperature and if
the temperature decreases, the water will be
agglomerate to form dew, which is called the fog
phenomenon.
If the mirage appears on light fittings of vehicle,
within the 30 minutes after the upper beam lamp
and lower beam lamp are opened, the mirage
appears on headlamp glass lens begins to
dissipate and disappears after 1 hour, and this is a
normal phenomenon. Or else, there may be water
exists. Please contact the designated service
stations for authentication and repair.
48
When replacing the bulb, strictly
check the installation of each part of lamp to
make sure the correction of installation and
good seal! Or else, the serious result that the
water and ash enter the light fittings will
happen!
The high-pressure water jet mustn't
be used for washing engine compartment,
especially the lighting fittings. If it is used,
due to the high pressure it gets, the
accessory on lighting fittings may loose and
fall off, and the air hole, wiring harness and
plug-in part will get wet. As a result, the
water exists in the lighting fittings or the
vapor doesn't dissipate, which will create
huge amounts of dew.

Headlamp Switch

OFF turn off exterior lamps
Position 1
the clearance lamp, instrument
and switch parts luminous light and license plate
lamp is turned on.
Position 2
turn on low beam of headlamp
Note:
The headlamp can work only after turning on
ignition switch. When engine is starting up or after
turning off the ignition switch, the headlamp will go
off automatically.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents