Washer System Of Windshield; Inspection Of Wiper Blade; Replacement Of Wiper Blade; Tyre - Chery Tiggo Owner's Manual

Washer System of Windshield

Please use the specified windshield cleaning fluid.
It is dangerous to drive the vehicle
without cleaning fluid, so please check the
cleaning fluid level before driving. The
anti-freezing fluid will cause damage to the
paint; therefore
1. Do not add anti-freezing fluid into
windshield washer fluid reservoir.
2. Do not mix water with the cleaning fluid;
since water may be frozen and cause
damage to washer fluid reservoir and other
components of washing system.
3. The using of unqualified cleaning fluid will
also cause damage to washing system.

Inspection of Wiper Blade

Inspect the roughness of wiper blade by sliding the
fingertip on the edge of this blade. Great
roughness will affect the wiper cleaning effect.
Butter, silicone resin and fuel may disable the
wiper blade from normally working. It is
recommended to use the glass cleaning fluid to
clean the wiper blade.

Replacement of Wiper Blade

To remove the wiper blade, arise the wiper arm
and make it form a right angle with the wiper blade.
please press the fixing clip according to the
direction shown by arrow, then release the wiper
blade, and finally pull out the wiper arm according
to the opposite direction.
Maintenance

Tyre

For your safety, please check the tyre pressure
after the tyres (including spare tyre) become cold.
See the proposed tyre pressure in the chapter
"Capacity and Specification".
The correct tyre pressure should be complied with
especially during the high-load and high-speed
running. The insufficient tyre pressure will reduce
the stability, increase the rolling resistance and
advance tyre abrasion and even lead to the
accident.
If you need to drive the vehicle on the curb, you
have to keep a low running speed, and if possible,
make the wheels close to curb at right angle. Avoid
the vertical and sharp obstructions. When parking
the vehicle, do not have the side wall of tyre
scratched.
Regularly inspect tyre surface for cut trace, foreign
body and uneven wear. The uneven tread wear
may indicate the incorrect alignment of wheel.
121