Supervisor/User Password; Ide Hdd Auto Detection - JETWAY J-791A User Manual

Onboard Parallel port Mode: This field allows the user to select the parallel port mode.
•
The default value is ECP + EPP.
Normal: Standard mode. IBM PC/AT Compatible bidirectional parallel port.
EPP: Enhanced Parallel Port mode.
ECP: Extended Capabilities Port mode.
EPP+ECP: ECP Mode & EPP Mode.
Power On Function: This field allower the user to select Power On method by button,
•
password or hot-key.
Button Only: Power On by press the button only.
Password:
Hot-Key:

3-9 SUPERVISOR/USER PASSWORD

This item lets you configure the system so that a password is required each time the system
boots or an attempt is made to enter the Setup program (Refer to Figure 3-3 for the details).
Supervisor Password allows you to change all CMOS settings but the User Password setting
doesn't have this function. The way to set up the passwords for both Supervisor and User are
as follow:
1. Choose either Supervisor Password or User Password in the Main Menu and press
<Enter>. The following message appears:
"Enter Password:"
2. The first time you run this option, enter your password up to only 8 characters and press
<Enter>. The screen does not display the entered characters. For no password just press
<Enter>.
3. After you enter the password, the following message appears prompting you to confirm
the password:
"Confirm Password:"
4. Enter exact the same password you just typed again to confirm the password and press
<Enter>.
5. Move the cursor to Save & Exit Setup to save the password.
6. If you need to delete the password you entered before, choose the Supervisor Password and
Press <Enter>. It will delete the password that you bad before.
7. Move the cursor to Save & Exit Setup to save the option you did, otherwise the old
password will still be there when you turn on your machine next time.

3-10 IDE HDD AUTO DETECTION

The "IDE HDD AUTO DETECTION" utility is a very useful tool especially when you do not
know which kind of hard disk type you are using. You can use this utility to detect the correct
disk type and install in the system automatically. Also you can set HARD DISK TYPE to
"Auto" in the STANDARD CMOS SETUP to have same result. The BIOS will Auto-detect the
hard disk size and model on display during POST.
!
Allow Power On by enter password correct by only.
Allow Power On by enter special defined hot-key only.
28