System Memory (Dram); Central Processing Unit (Cpu) - JETWAY J-791A User Manual

2-3-2 System Memory (DRAM)

This motherboard support tree168-pin DIMM Module, using +3V unbuffer synchronous DRAM
in either EDO or SDRAM with Max. memory size of 768MB.
DIMM1 DIMM2
16MB
16MB
16MB
32MB
32MB
32MB
64MB
64MB
64MB
128MB
128MB
128MB
256MB
256MB
256MB

2-4 Central Processing Unit (CPU)

The motherboard provides a Slot-1 for Pentium II processor. The CPU on board must have a
fan or heat sink attached to prevent overheating.
WARNING: Without a fan or heat sink, the CPU will overheat and cause damage to both the CPU
and the motherboard.
To install a CPU, first turn off your system and remove its cover. Locate the Slot- 1 and place
RETENTION MODULE as following:
IMPORTANT: You must setswitch U4,U2 for both "CPU to Bus frequency Ratio" and "Bus
Frequency Selection" on
Œ
Attach heat sink to the CPU.
 Place Part A on slot-1 and gently screw four corners on top of the mother-board.
!
DIMM3
none none
16MB none
16MB 16MB
none none
32MB none
32MB 32MB
none none
64MB none
64MB 64MB
none none
128MB none
128MB 128MB
none none
256MB none
256MB 256MB
Total Memory
Combination
16MB
32MB
48MB
32MB
64MB
96MB
64MB
128MB
192MB
128MB
256MB
384MB
256MB
512MB
768MB
page 7 depending on the CPU that you install.
8