Table of Contents
Advertisement
100MHz/133MHz. The setting are 100MHz, 133MHz, 166MHz.
PCI Clock Ratio
This item allows you to set PCI Clock Ratio. The choice are: Host/3, Host/4, Host/5, Host/6.
CPU Vcore Select
This item allows you select CPU Vcore Voltage by increase 0.025V step by step from 1.6V to
1.850V the Default setting is Default (CPU manufacturer Default setting).
VAGP Output 1.5V Select (1.5V Default)
This item allows you to select 1.5V of the AGP VGA card. The choice are: Default, 1.5V, 1.6V,
1.7V, 1.8V.
VRAM Output 2.5V Select (2.5V Default)
This item allows you to select DRAM Voltage. The choice are: 2.5V, 2.6V, 2.7V, 2.8V, 2.9V,
3.0V.
VTT Voltage 1/2 VRAM (1/2 VRAM Default)
This item allows you to select 1/2 VRAM or Fix in 1.25V.
Flash Part Write Protect
This item allows you protect your BIOS chip from Virus destroy data. When Flash BIOS you have
Disabled this item.
3-12 Load Standard/Optimized Defaults
Load Standard Defaults
When you press <Enter> on this item, you get confirmation dialog box with a message
similar to:
Load Standard Defaults (Y/N)? N
Pressing <Y> loads the BIOS default values for the most stable, minimal-performance
system operations.
Load Optimized Defaults
When you press <Enter> on this item, you get a confirmation dialog box with a message
similar to:
Load Optimized Defaults (Y/N)? N
Pressing <Y> loads the default values that are factory settings for optimal performance
system operations.
3-13 Set Supervisor/User Password
You can set either supervisor or user password, or both of them. The differences are:
Supervisor password:
User password:
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>. The password
typed now will clear any previously entered password from CMOS memory. You will be
asked to confirm the password. Type the password again and press <Enter>. You may
also press <Esc> to abort the selection and not enter a password.
To disable a password, just press <Enter> when you are prompted to enter the password.
Can enter and change the options of the setup menus.
Can only enter but do not have the right to change the options of
the setup menus. When you select this function, the following
message will appear at the center of the screen to assist you in
creating a password.
33
Advertisement
Table of Contents
