JETWAY J-791A User Manual page 28

IDE Secondary Slave PIO: The default value is
•
Auto: BIOS will automatically detect the Onboard Secondary Slave PCI IDE HDD
Accessing mode.
Mode0~4: Manually set the IDE Accessing mode.
Onboard Primary PCI IDE: The default value is Enabled.
•
Enabled: Enable Onboard 1 st channel IDE port.
Disabled: Disable Onboard 1 st channel IDE port. When use On-card (PCI or ISA card)
IDE connector.
Onboard Secondary PCI IDE: The default value is Enabled.
•
Enabled: Enable Onboard 2 nd channel IDE port.
Disabled: Disable Onboard 2 nd channel IDE port. When use On-card (PCI or ISA card)
IDE connector.
PCI Slot IDE 2nd Channel: The default value is Enabled.
•
Enabled: Enable secondary IDE port and BIOS will assign IRQ15 for this port.
Disabled: Disable secondary IDE port and IRQ15 is available for other device.
Onboard FDC Controller: The default value Enabled.
•
Enabled: Enable the Onboard floppy drive interface controller.
Disabled: Disable the Onboard floppy drive interface controller. When use On-card ISA
FDC's controller.
Onboard Serial Port 1: This field allows the user to select the serial port. The default
•
value is COM1.
COM1: Enable Onboard Serial port 1 and address is 3F8H.
COM2: Enable Onboard Serial port 1 and address is 2F8H.
COM3: Enable Onboard Serial port 1 and address is 3E8H.
COM4: Enable Onboard Serial port 1 and address is 2E8H.
Disabled: Disable Onboard CHIP's Serial port 1.
Onboard Serial port 2: This field allows the user to select the serial port. The default
•
value is COM2.
COM1: Enable Onboard Serial port 2 and address is 3F8H.
COM2: Enable Onboard Serial port 2 and address is 2F8H.
COM3: Enable Onboard Serial port 2 and address is 3E8H.
COM4: Enable Onboard Serial port 2 and address is 2E8H.
Disabled: Disable Onboard CHIP's Serial port 2.
Onboard Parallel port: This field allows the user to select the LPT port. The default
•
value is 378H.
378H: Enable Onboard LPT port and address is 378H.
278H: Enable Onboard LPT port and address is 278H.
3BCH: Enable Onboard LPT port and address is 3BCH.
Disabled: Disable Onboard CHIP's LPT port.
NOTE: Parallel Port address is 378H/3BCH that selects the rounting of IRQ7 for LPT1.
Parallel Port address is 278H that selects the rounting of IRQ5 LPT1.
!
27