Table of Contents
Advertisement
Quick Links
INSTALLATION CERTIFICATE
The undersigned,qualified installer, attests to have personally fitted the here
described vehicle security system following the manufacturer instructions.
By :
7590T
Product Type :
Sold on :
...................................
Art. Code 7590TK15
Vehicle
...........................................................
INSTALLATION AND
USE MANUAL
Signature
..........................................................................................
GEMINI Technologies S.p.A.
Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italy
Tel. +39 0332 943211 - Fax +39 0332 948080
www.gemini-alarm.com
AC2594 Rev.02-06/14
Made in Italy
ISO 9001 Certified Company
Advertisement
Table of Contents
Related Manuals for Gemini 7590T
Summary of Contents for Gemini 7590T
- Page 1 Vehicle ............INSTALLATION AND USE MANUAL Signature ..................GEMINI Technologies S.p.A. Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italy Tel. +39 0332 943211 - Fax +39 0332 948080 www.gemini-alarm.com AC2594 Rev.02-06/14 Made in Italy ISO 9001 Certified Company...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Dear customer - PRELIMINARY ADVICE The 7590T is a Thatcham alarm unit with dual point immobilization and built- - FUNCTIONS in sensors designed to be used only on vehicles with a negatively grounded - REMOTE CONTROL OPERATION AND BATTERY REPLACEMENT 12V battery. -
Page 3: Remote Control Operation And Battery Replacement
USER MANUAL 3.0 - REMOTE CONTROL OPERATION 4.0 - OPERATING INSTRUCTIONS AND BATTERY REPLACEMENT 4.1 ALARM ARMING To arm the alarm press remote control button 1 or touch the electronic key to its BUTTON 1: receptacle. Arming is confirmed by a quick flash of the turn indicators. COMPLETE SYSTEM ARMING SYSTEM DISARMING The following functions are enabled:... -
Page 4: Alarm Conditions
4.7 - NEUTRAL TIME BETWEEN ALARM CYCLES 4.5 - ALARM CONDITIONS Wire tamper ( via the self-powered siren). After the alarm is triggered, but before another alarm cycle starts, there is a 5” interval during which there will be no reaction to alarm events. The LED Ignition attempt. -
Page 5: Installer Manual
INSTALLER MANUAL 6.0 - WIRING DIAGRAM ANTENNA - Do not tamper! ART.7590T 5.0 - ELECTRICAL CONNECTIONS ELECTRONIC KEY Implement the electrical engine blocks by working on the fuel pump and the starter motor. ALARM SYSTEMS Connect the alarm positive supply to the vehicle battery or to one of its... -
Page 6: Programming The Alarm System
7.0 - PROGRAMMING THE ALARM SYSTEM 8.0 - PROGRAMMABLE FUNCTIONS The alarm system has been factory configured but settings can be modified at 8.1 - ACOUSTIC SIGNALS any time. This function allows to permanently exclude all acoustic signals. See the During programming, proceed as follows: relative paragraph for programming. -
Page 7: Passive Arming
8.5 - PASSIVE ARMING 10.0 - LEARNING NEW CONTROL DEVICES Engine block passive arming, if enabled, automatically activates the double To carry out the operation successfully, make sure the required electrical ENGINE LOCK 60 sec. after the engine has been switched OFF or 60 sec. connections (door /bonnet switch and ignition) have been completed. -
Page 8: Directive
Health and Safety of the user and any other person and in Art. 3.1 (b) for certificate is not fully compiled or if the enclosed sale document is missing. Elecromagnetic Compatibility, as included in the following standards: The warranty is valid exclusively at Authorized Gemini Technologies Service Centers. Art. of Directive...