Configuring A Server Interface; Configuring Npv Traffic Management; Configuring Npv Traffic Maps - Cisco Nexus 5500 Series NX-OS Configuration Manual

Configuring NPV
Procedure
Step 1
Step 2
Step 3
Step 4

Configuring a Server Interface

To configure a server interface, perform this task:
Procedure
Step 1
Step 2
Step 3
Step 4

Configuring NPV Traffic Management

Configuring NPV Traffic Maps

An NPV traffic map associates one or more NP uplink interfaces with a server interface. The switch associates
the server interface with one of these NP uplinks.
If a server interface is already mapped to an NP uplink, you should include this mapping in the traffic
Note
map configuration.
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
58
Command or Action
switch# configure terminal
switch(config)# interface fc slot/port
switch(config-if)# switchport mode NP
switch(config-if)# no shutdown
Command or Action
switch# configure terminal
switch(config)# interface fc slot/port
switch(config-if)# switchport mode F
switch(config-if)# no shutdown
Configuring N Port Virtualization
Purpose
Enters global configuration mode.
Selects an interface that will be connected to the
core NPV switch.
If this is a QSFP+ GEM, the slot/port
Note
syntax is slot/QSFP-module/port.
Configures the interface as an NP port.
Brings up the interface.
Purpose
Enters global configuration mode.
Selects an interface that will be connected to the
core NPV switch.
Note If this is a QSFP+ GEM, the slot/port
syntax is slot/QSFP-module/port.
Configures the interface as an F port.
Brings up the interface.
OL-30895-01