Default Settings For Fsfp - Cisco Nexus 5500 Series NX-OS Configuration Manual

Configuring Fibre Channel Routing Services and Protocols
The following example shows how to display global FSPF information for a specific VSAN:
switch# show fspf vsan 1
The following example shows how to display a summary of the FSPF database for a specified VSAN. If no
additional parameters are specified, all LSRs in the database are displayed:
switch# show fspf database vsan 1
The following example shows how to display FSPF interface information:
switch# show fspf vsan 1 interface fc2/1

Default Settings for FSFP

The following table lists the default settings for FSPF features.
Table 27: Default FSPF Settings
Parameters
FSPF
SPF computation
SPF hold time
Backbone region
Acknowledgment interval (RxmtInterval)
Refresh time (LSRefreshTime)
Maximum age (MaxAge)
Hello interval
Dead interval
Distribution tree information
Routing table
Load balancing
In-order delivery
Drop latency
Static route cost
OL-30895-01
Default
Enabled on all E ports and TE ports
Dynamic
0
0
5 seconds
30 minutes
60 minutes
20 seconds
80 seconds
Derived from the principal switch (root node)
FSPF stores up to 16 equal cost paths to a given
destination
Based on destination ID and source ID on different,
equal cost paths
Disabled
Disabled
If the cost (metric) of the route is not specified, the
default is 10
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
Default Settings for FSFP
185