Configuring Fibre Channel Domain Parameters
Step 2
Step 3
About fcdomain Initiation
By default, the fcdomain feature is enabled on each switch. If you disable the fcdomain feature in a switch,
that switch can no longer participate with other switches in the fabric. The fcdomain configuration is applied
to runtime through a disruptive restart.
Disabling or Reenabling fcdomains
To disable or reenable fcdomains in a single VSAN or a range of VSANs, perform this task:
Procedure
Step 1
Step 2
Step 3
Configuring Fabric Names
You can set the fabric name value for a disabled fcdomain.
OL-30895-01
Command or Action
fcdomain priority number vsan vsan-id
Example:
switch(config)# fcdomain priority 12
vsan 1
no fcdomain priority number vsan
vsan-id
Example:
switch(config)# no fcdomain priority
12 vsan 1
Command or Action
switch# configure terminal
switch(config)# no fcdomain vsan vsan-id
- vsan-id
switch(config)# fcdomain vsan vsan-id
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
Fibre Channel Domains
Purpose
Configures the specified priority for the local switch
in the specified VSAN. The fcdomain priority
ranges from 1 to 254. The VSAN ID ranges from 1
to 4093.
Reverts the priority to the factory default (128) in
the specified VSAN. The fcdomain priority ranges
from 1 to 254. The VSAN ID ranges from 1 to 4093.
Purpose
Enters global configuration mode.
Disables the fcdomain configuration in the
specified VSAN range.
Enables the fcdomain configuration in the
specified VSAN.
33