Ricoh PRO 8100S Operating Instructions Manual page 60

3. Troubleshooting Image Quality Problems
4. Check the type of your machine. Is it Pro 8100S?
Yes No further improvement is likely. Contact your service representative.
No Perform Procedure 2, "Changing the process speed".
Procedure 2: Changing the process speed
This procedure is available only for Pro 8120S and Pro 8110S.
This will slow down the printing to give the toner more time to fuse. However, because of this,
throughput will be reduced.
Example when printing on A4/LT paper:
<Pro 8120S>
If the process speed is changed from [High] to [Middle]: 135 cpm
If the process speed is changed from [Middle] to [Low]: 110 cpm
<Pro 8110S>
If the process speed is changed from [High] to [Low]: 110 cpm
Pro 8110S does not have the [Middle] setting.
1. In [Advanced Settings] for the custom paper in use, select [Process Speed Setting].
2. Decrease the value by one level.
If the present value is [High], select [Middle]. If it is [Middle], select [Low].
3. Print the image and check toner fusion. Is the problem resolved?
Yes Finished!
No If the problem persists, the machine may be faulty or the paper unsupported. Contact
your service representative.
58
110 cpm
95 cpm
95 cpm