Ricoh PRO 8100S Operating Instructions Manual page 48

3. Troubleshooting Image Quality Problems
Solution:
Before you perform the solution procedure, make sure that the environmental conditions where you are
using the machine meet those recommended for use. For details on the environmental conditions for use,
see "Where to Put Your Machine", About This Machine.
The solution depends on the interval.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings Reference.
Approximately 12-18 mm (0.5-0.7 inches)
Approximately 60 mm (2.4 inches)
Approximately 95 mm (3.7 inches)
Approximately 314 mm (12.4 inches)
• For details about replacing the photoconductor unit, see Replacement Guide.
46
Interval
CWH407
Solution
Contact your service representative.
In [Advanced Settings] for the custom paper in use,
adjust the value in [Transfer Timing Roller Feed Speed
Adj] according to the type and thickness of paper in
use. If the problem persists, contact your service
representative.
Contact your service representative.
Replace the photoconductor unit. If the problem
persists, contact your service representative.