Ricoh PRO 8100S Operating Instructions Manual page 126

6. Improving Throughput
Improving Throughput When Printing on
Coated Paper with a Thickness Equivalent to
Paper Weight 7 or Higher
When printing on coated paper with a thickness equivalent to Paper Weight 7 or higher, the machine's
copy/print speed must be reduced to 80% of full speed (for A4 paper) so that the degree of toner
fixation can be enhanced.
However, depending on the type of paper in use and printed image, you can have the machine print at
full copy/print speed.
The following are requirements for improving throughput when using coated paper with a thickness
equivalent to Paper Weight 7 or higher:
• Room temperature
1. In [Advanced Settings] for the custom paper in use, increase the value in [Process Speed
Setting] by one step.
• If it is presently set to [Low], change it to [Middle].
• If it is presently set to [Middle], change it to [High].
2. Set [Fusing Heat Roller Temperature Adj] to "185°C".
3. Print the image. Does it exhibit any fusing problem?
Yes You cannot improve throughput under the present condition. Restore the previous setting.
No You can operate the machine using this setting.
• The following list shows the copy/print speed for each item in [Process Speed Setting]:
• [High] (full speed)
135 cpm (Pro 8120S)
110 cpm (Pro 8110S)
95 cpm (Pro 8100S)
• [Middle]
110 cpm (Pro 8120S)
• [Low]
95 cpm (Pro 8120S)
95 cpm (Pro 8110S)
124
EN EN EN
GB US AU
D181-2539