Ricoh PRO 8100S Operating Instructions Manual page 32

3. Troubleshooting Image Quality Problems
a) Line splatter that is 15 mm (0.6 inches) or less from the leading edge
Increase the leading edge margin to more than 15 mm (0.6 inches) using one of the following
procedures:
1. Adjusting the shift image
In [Advanced Settings] for the custom paper in use, specify [Adj Image Position of Side1 With
Feed] for the side 1 of the paper and [Adj Image Position of Side2 With Feed] for the side 2.
2. Adjusting the mask width at the leading edge
In [Advanced Settings] for the custom paper in use, specify [Adjust Erase Margin of Leading
Edge].
3. Adjusting the file's leading edge margin
Increase the leading edge margin in the print settings for the image to be printed.
For details about adjusting the shift image and adjusting the mask width at the leading edge, see
"Adjustment Item Menu Guide".
If you cannot increase the leading edge margin to more than 15 mm (0.6 inches), contact your
service representative.
b) Line splatter that is in an area more than 15 mm (0.6 inches) from the leading edge
1. In [Advanced Settings] for the custom paper in use, select [Image Transfer Current Setting].
2. Check the present value. Is it the upper limit?
Yes Go to Step 5.
No Go to the next step.
3. Increase the absolute value of the current by 5 A in [Image Transfer Current Setting].
4. Print the image. Is the problem resolved?
Yes Finished!
No Increase the value by 5 A. If the problem persists even though you have increased
the value to the upper limit (150 A), go to the next step.
5. Do you mind if image density is low?
Yes Contact your service representative.
No Go to the next step.
6. In [Advanced Settings] for the custom paper in use, select [Adjust Toner Adhesion].
7. Check the present value. Is it the lower limit?
Yes Contact your service representative.
30