Ricoh PRO 8100S Operating Instructions Manual page 25

Cause:
The exit drive rollers, exit idle rollers, exit relay drive rollers, or exit relay idle rollers in the drawer are
soiled.
Solution:
Clean the rollers, sensors, and guide boards in the drawer.
1. Make sure that the system is turned off and the machine power cord is disconnected from
the power source.
2. Open the front covers.
3. Lower the levers C1 and C2, and then pull the drawer out completely until it stops.
4. Pull up and open the cover D3.
5. Clean the rollers while turning the knob D1. Clean the sensors and guide boards also.
For details about cleaning the parts, see page 85 "Cleaning the Paper Feed Path".
CZC300
CZC341
Toner Spotting/Staining
23