Verification Stamp - Konica Minolta 7145 Internet Fax / Fax Operations

Setting Transmission Conditions - (continued)

Verification Stamp

When transmitting a fax via the RADF, a stamp can be affixed to the pages of the document
that have already been scanned, allowing you to confirm that these pages have been
scanned. The stamp is a pink circle, 3mm in diameter and affixed at the rear edge on the front
side of the original document. When both sides of a sheet are transmitted, the stamp is affixed
respectively on the front side.
transmitting direction
DETAILS
•
The stamp ink must be replaced when it runs out. When color of the verification stamp
becomes light, contact your service representative for a replacement.
•
When mixed original mode is selected, no stamp may be affixed to the above position.
•
Even though the Verification Stamp function has been set, no Verification Stamp is put if
the document is transmitted in the multi-feeding. In such a case, transmit the document
again.
•
Check if the document was correctly transmitted by the Transmission Report or Transmit
Result of the CHECK MODE.
For detail about replacing the stamp, refer to "Replacing the Stamp" (p. Appendix-5).
6-12
Front surface of
original document
Original document
Stamp position