Konica Minolta 7145 Internet Fax / Fax Operations page 192

Application Functions Overview - (continued)
• Special Original :
• Mixed original :
• Folded original: This function allows you to read and transmit a document having folds
• Long original:
• Flip Side 2:
• Polled Tx :
• Polling Rx :
• Timer Tx :
• Int'l com :
• ECM off :
• Confiden. Tx
• V34 OFF :
• Bulletin *1
:
• ID Tx *2
:
10-6
This includes three functions as follows.
You can send document pages of mixed sizes in a single sequence of
operations. (p. 10-19)
that would typically hinder the machine from detecting the document
size properly. (p. 10-22)
This function allows transmitting pages longer than the length (431
mm) of A3 size. (p. 10-25)
When reading a document that has pages printed on both sides, with
the aid of the RADF, this function allows you to specify to compensate
for reading the overturned pages. (p. 10-27)
This function allows you to read a document and store it in memory
until the remote station initiates transmission by sending a command
to receive (polling). (p. 12-2)
This function allows you to initiate reception by sending a command to
a remote station to receive a document that is set for transmission at
the remote station. (p. 12-4)
The time to start communication can be specified. (p. 6-44)
A lower baud rate will be employed. (p. 6-47)
Error Correction Mode (ECM) can be disabled. (p. 10-30)
*1
: You can use Restricted access boxes (like email accounts) to
exchange private information with specific persons. You can not only
send information to a restricted access box of a remote station
(Restricted access transmission) but receive in a restricted access
box from your own station (Restricted access reception). (p. 10-33)
When the V34 protocol can not be used due to restrictions of
exchange equipment, the V34 mode is disabled for transmission. (p.
10-39)
Bulletin boards can be used to store documents to be transmitted by
polling. (p. 12-6)
Transmission can be sent with a password attached, as required when
the receiving station is using a closed area communication mode.
(p. 10-41)