Table of Contents
Advertisement
Points to note at installation
When attaching the terminal [1], make sure that the contact spring [2]
contacts as shown.
[1]
[2]
3.1.13.3 Before Removing the Paper Leading Edge
Sensor
LBP6000 / LBP6000B
1) Remove the Upper Cover. (page 3-5)Reference[Removing the Upper
Cover]
2) Remove the Left Cover. (page 3-3)Reference[Removing the Left Cov-
er]
3) Remove the Right Cover. (page 3-2)Reference[Removing the Right
Cover]
4) Remove the Rear Cover. (page 3-1)Reference[Removing the Rear Cov-
er]
5) Remove the Main Controller PCB. (page 3-17)Reference[Removing the
Main Controller PCB]
3.1.13.4 Removing the Paper Leading Edge Sensor
LBP6000 / LBP6000B
1) Remove the terminal [1], and free the harness [3] from the Harness Guide
[2].
[2]
[1]
2) Disconnect the 4 connectors [1], and free the harness [3] from the Harness
Guide [2].
3) Remove the Paper Leading Edge Sensor [4].
[3]
F-3-77
0025-1232
Points to Note at Installation
When installing the terminal [1], be sure that the Contact Spring [2] is in
contact with it as shown below.
0025-1233
[1]
[2]
3.1.14 Sensor Boade
3.1.14.1 Preparation for Removing the Sensor PCB
LBP3100 / LBP3010B
1) Removing the Upper Cover (page 3-3)Reference[Removing the Upper
Cover]
2) Removing the Left Cover (page 3-2)Reference[Removing the Left Cov-
er]
3) Removing the Right Cover (page 3-2)Reference[Removing the Right
Cover]
4) Removing the Rear Cover (page 3-1)Reference[Removing the Rear
Cover]
5) Removing the Main Controller PCB (page 3-17)Reference[Removing
the Main Controller PCB]
3.1.14.2 Removing the Sensor PCB
LBP3100 / LBP3010B
[2]
[3]
[4]
F-3-78
Chapter 3
[1]
[1]
0019-4218
0019-4219
3-23
Advertisement
Table of Contents
