Predefined Values For 68000 Emulator Status - HP 64700 series User Manual

Qualifier Status Bits (31..24)
byte 0xxxx xxx1Y
cyc6800 0xxxx x0xxY
data 0xxx0 1xxxY
dma 0xx01 1xxxY
grd 00xxx xxxxY
intack 0xx11 1xxxY
prog 0xxx1 0xxxY
read 0xxxx xx1xY
super 0xx1x xxxxY
supdata 0xx10 1xxxY
supprog 0xx11 0xxxY
user 0xx0x xxxxY
userdata 0xx00 1xxxY
userprog 0xx01 0xxxY
word 0xxxx xxx0Y
write 0xxxx xx0xY
wrrom 0x0xx xx0xY
data Represents the trace signals which monitor the
emulation processor's data pins (trace signals 32
through 47 in the 68000 emulator).
stat Represents the trace signals which monitor other
emulation processor signals (trace signals 24
through 31 in the 68000 emulator).
xbits Represents the external trace signals. This trace
label is only available if an external analyzer is
present and aligned with the internal analyzer.
These trace labels are predefined. You can define additional trace
labels in the screen presented with the "Analysis Format" command.
Refer to the "Changing the Display Format" section that appears later
in this chapter.
The trace signals associated with the addr, data, and stat trace labels are
different for each emulator. Other emulators may provide additional
trace labels to choose from.
Predefined Values for 68000 Emulator Status. Move the cursor
to the "stat" field of a pattern resource. Notice that a line on which you
can enter status values appears on the bottom part of the screen. Use
the Tab key to view the predefined values. The predefined values for
the 68000 emulator are:
Description
Byte cycle.
6800 peripheral cycle.
Data cycle.
DMA cycle.
Guarded memory access.
Interrupt acknowledge cycle.
Program cycle.
Read cycle.
Supervisor cycle.
Supervisor data cycle.
Supervisor program cycle.
User cycle.
User data cycle.
User program cycle.
Word cycle.
Write cycle.
Write to ROM.
Using the Analyzer 2-11