Occurrence Count Field; Branches - HP 64700 series User Manual

Occurrence Count Field

The occurrence count field specifies the number of times the state
specified in the find/trigger field must be found before the analyzer
goes on to the following sequence level.
The default base for an occurrence count is decimal. You may specify
occurrence counts from 1 to 65535.

Branches

Branches alter the analyzer's search sequence if the specified branch
state occurs before the find/trigger state.
When branches are turned off, the analyzer searches for the first
sequence level's find/trigger state; when this state is found, the
analyzer searches for the second sequence level's find/trigger state, and
so on.
When branches are turned on, the analyzer searches for find/trigger
states associated with each sequence level; if the find/trigger state is
found before the branch state, the analyzer still continues its search at
the following sequence level. However, if the branch state is found
before the find/trigger state, the analyzer can continue its search at a
different sequence level.
off
restart on
per level
Branches are turned off. The analyzer searches
only for the states defined in the find/trigger fields,
starting with the first sequence level, then the
second, and so on.
Branches are turned on. You are given another
field in which to specify the restart state qualifier.
This restart qualifier is used for all sequence levels,
and the branch is always back to the first sequence
level. This is also known as "global restart"
because the same restart condition applies to all
sequence levels.
Branches are turned on. Two additional fields are
added to each sequence level except the last: one
for the branch state qualifier, and one to specify the
sequence level the analyzer branches to if the
branch state is found before the find/trigger state.
Using the Analyzer 2-5