Connecting The Hp Processor Probe To A Power Source; To Choose A Power Cord - HP E3494A Installation And Service Manual

Connecting the HP processor probe to a Power
Source
The HP processor probe does not have an On/Off switch. To turn the
HP processor probe on or off, plug or unplug it from the power supply.

To choose a power cord

The HP processor probe is shipped from the factory with a power supply and
cord appropriate for your country. You should verify that you have the
correct power cable for installation by comparing the power cord you
received with the HP processor probe with the drawings under the "Plug
Type" column of the following table.
If the cord you received is not appropriate for your electrical power outlet
type, contact your Hewlett-Packard sales and service office.
Use only the supplied HP power supply and cord.
W a r n i n g
Failure to use the proper power supply could result in electric shock.
C a u t i o n
Use only the supplied HP power supply and cord.
Failure to use the proper power supply could result in equipment damage.
Connecting to the Host Computer
To choose a power cord
5