Heat Controller
3.6 Swing Setting
Swing On: Press Function under on state of the unit to activate the swing function. In
this case,
When the Swing function is on, press Function to enter the Swing setting interface, with
blinking. After that, press Enter/Cancel to cancel this function. Swing setting is shown as Fig. 9.
Turn on the unit, without
turning on swing function
Notes:
Sleep, Turbo or Blow setting is the same as the Swing setting.
j
After adjusting the setting press the key "Enter/Cancel" to go back to the setting status or
k
quit automatically five seconds late.
will blink. After that, press Enter/Cancel to make a confirmation Swing Off:
Press "Function" button into
Press "Enter/Cancel" to
B-VFH-1 Multi-Zone Wireless / Wired Remote Control
swing state
cancel swing
Fig. 9 Swing Setting
7
Press "Enter/Cancel" to confirm
Press "Function" button
into swing state