Table of Contents
Advertisement
B-VFH-1 Multi-Zone Wireless / Wired Remote Control
Heat Controller
11) TEMP
Indoor/outdoor temp. can be decided by pressing this button which temperature will be displayed. When the
indoor unit is powered on, the indoor set temperature will be displayed. If the status is changed to
, the
indoor ambient temperature will be displayed. However, the indoor set temperature will be displayed again
when the controller receives other remote control signals. Without setting this function, the default is the indoor
set temperature.
12) SWING UP/DOWN (
)
The swing angle which circularly changes as below can be selected by pressing this button:
This kind of remote controller is universal. And the three swing statuses of
are the same as that of
.
If the swing function is deactivated when the air guide louver swings up and down, it will stop at the current
position.
indicates that the air guide louver swings up and down among all five positions
13) AIR (
)
AIR ON or Air OFF can be selected by pressing this button.
14) TIMER ON
"ON" will be displayed and blink for 5 seconds by pressing this button. Quickly adjust the time by pressing +
or - within 5 seconds. Each press will make the time increase or decrease by 1 minute. If the button is pressed
down for more than 2 seconds, the time will be changed quickly in such a way: first the value on the one's
place is changed and then the value on the ten's place. Once Timer ON has been set, it can be cancelled by
pressing it again. Before setting, please adjust the CLOCK to the current actual time.
15) TIMER OFF
TIME OFF can be activated by pressing this button, with "OFF" blinking. The method of setting is the same as
that for TIMER ON.
16) HEALTH ( )
This function can be activated or deactivated by pressing this button. After the unit is turned on, the default is
HEALTH ON.
17) I FEEL
This function can be activated by pressing this button and canceled by another press. When this function is
on, the I FEEL information will be sent out in 200 ms after each operation on the controller and the remote
controller will send the temperature information to the main controller every 10 minutes.
18
Advertisement
Table of Contents
