Table of Contents
Advertisement
B-VFH-1 Multi-Zone Wireless / Wired Remote Control
Fig. 15 shows the installation steps of the wired remote controller, but there are some issues that need your
attention.
(1). Prior to the installation, please first cut off the power supply of the wire buried in the installation hole, that
is, no operation is allowed with electricity during the whole installation.
(2). Pull out the four-core twisted pair line from the installation holes and then let it go through the rectangular
hole behind the baseplate of the wired remote controller.
(3). Stick the baseplate of the wired remote controller to the wall over the installation hole and then fix it with
screws M4X25.
(4). Insert the four-core twisted pair line into the slot of the wired remote controller and then snap the front
panel and the baseplate of the wired remote controller together.
(5). Finally, fix the front panel and the baseplate of the wired remote controller tightly by screws ST2.9X6.
Fig. 15
14
Heat Controller
Advertisement
Table of Contents
