Table of Contents
Advertisement
Heat Controller
4 Installation and Dismantlement
4.1 Connection of the Signal Line of the Wired Remote Controller
● Open the cover of the electric control box of the indoor unit.
● Feed the single line of the wired remote controller through the rubber ring.
● Connect the signal line of the wired remote controller to the 4-pin socket of the indoor unit
PCB.
● Tighten the signal wire with ties.
● The communication distance between the main board and the wired remote controller can be
up to 65 ft. ( the standard distance is 26 ft.)
4.2 Installation of the Wired Remote Controller
Fig. 14 Accessories for the Installation of the Wired Remote Controller
No.
Socket box
Name
embedded in
the wall
1
2
Base plate of the
Wired Remote
Controller
B-VFH-1 Multi-Zone Wireless / Wired Remote Control
Table 3
3
Front Panel of
Screw
M4X25
mote Controller
13
4
the Wired Re-
Screw ST2.9X6
5
Advertisement
Table of Contents
