Installing / Replacing Consumables - Lincoln Electric spirit II 150 Technical Manual

Spirit II User's Manual

Installing / Replacing Consumables

Note: When installing the consumables, do not use an excessive
amount of o-ring lubricant. Also ensure that the lubricant is placed only
on the o-rings. Excess lubricant can interfere with gas flow, which can
cause starting problems, poor cut quality, and short consumable life.
1. Unthread the torch head from the torch base by turning the attachment ring to
the LEFT. Verify the torch base doesn't unthread from the torch handle.
2. Remove the outer retaining cap from the torch head.
3. Remove the inner retaining cap from the torch head.
4. Separate the shield cap from either the inner retaining cap or the outer
retaining cap.
5. Use the nozzle removal tool (P/N BK277056) to remove the nozzle from the
torch head. To do this, insert the tool into the groove on the nozzle and hold
the tool/nozzle in the palm of your hand. Pull both hands apart using a linear
motion as shown in the left image below. Do not use a prying or bending
motion as shown in the right image below.
Continued on next page...
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
DANGER!
Electric Shock Can Kill.
•
Remove primary power from the Spirit system before installing or
removing the torch head.
WARNING!
Hot Parts Can Burn Skin.
•
Do not touch hot parts bare handed.
•
Always use gloves when handling the torch as it can be hot after
cutting, especially with high amperages and long cut times.
•
Allow cooling period before working on the torch.
Section 5: Torch Consumables and Cutting Charts
5-3