Network Settings Tab - Lincoln Electric spirit II 150 Technical Manual

Spirit II User's Manual

Network Settings Tab

Press the Config navigation button followed by the Network Settings tab to access the
screen described below.
To enable networking, press the red exclamation graphic next to Network
Disabled. The graphic will change to a green check mark. Enter the appropriate
IP Address, Subnet Mask, and Gateway.
If DHCP is necessary, press the red exclamation graphic next to DHCP Disabled.
The graphic will change to a green check mark. Enter the required information.
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Section 4: Operation with Automatic Gas Console
4-15