Lincoln Electric spirit II 150 Technical Manual page 172

Appendix B: Serial Communication
Command
Restore Factory
Condition
Cutting Condition
Type
Configure H17
Cutting
Reload Cutting
Condition
Set Arc Off Delay
Time
Machine Type
Set Marking Arc
Voltage
Set Marking Height
Set Marking Start
Height
Set Marking Travel
Speed
Set Marking Pierce
Time
Configure
Cut/Mark/Cut
Node Focus
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
# Hex String
47 AA nn FA 2F 00 01 0D
48 AA nn FA 30 00 -- 0D
49 AA nn FA 31 00 -- 0D
50 AA nn FA 32 00 01 0D
51 AA nn FA 33 -- -- 0D
52 AA nn FA 34 -- -- 0D
53 AA nn FA 35 -- -- 0D
54 AA nn FA 36 -- -- 0D
55 AA nn FA 37 -- -- 0D
56 AA nn FA 38 -- -- 0D
57 AA nn FA 39 -- -- 0D
59 AA nn FA 3B 00 -- 0D
254 AA C8 FA FE 00 nn 0D
B-8
Additional Information
Restores the factory cutting condition for the
present material type and thickness.
If requested in command #30, the system will
transmit whether the present cutting condition is a
factory default setting or a custom user setting.
Note: This is only valid when initially loading
material type, thickness, and process.
0 = factory / 1 = custom
0 = Disable H17 cutting
1 = Enable H17 cutting
Reloads the cutting conditions for the present
material type and thickness
Sets the delay time in mS between the reception
of a stop signal and the extinction of the arc.
Valid Range: 0 to 2000 mS
If requested in command #30, the system will
transmit the machine type.
153 = Spirit150a
203 = Spirit200a
273 = Spirit275a
403 = Spirit400a
Sets marking arc voltage in Volts x 100
Valid Range: 5000 to 20000
Sets marking height in mils (inches / 1000)
Valid Range: 0 to 999
Sets marking start height in mils (inches / 1000)
Valid Range: 0 to 999
Sets marking travel speed (inches / min)
Valid Range: 0 to 999
Sets marking pierce time in ms
Valid Range: 0 to 9999
0 = Local at power supply
1 = Hard signal via interface plug
2 = RS-422
Sends a global command to all systems and sets
the node focus to system nn
Spirit II User's Manual