Clearray On Demand; Adjusting Jet Flow; Adjusting Powerpro™ Mx2 Jets; Adjusting Rx Jets - Jacuzzi J-585 Owner's Manual

11.10 CLEARRAY on Demand

The CLEARRAY on demand feature
activates the water purification system
ON UV 6:45 PM
96
for a period of 1-hour. Tap to turn
the system on. During this time the
circulation pump and the CLEARRAY
unit are on. The button will have a blue
highlight when this feature is on.
Note: When the CLEARRAY system is
on due to a programmed or scheduled setting
the feature cannot be turned off.

11.11 Adjusting Jet Flow

The water flow to certain jets in your spa can be increased or
decreased by rotating the outside jet face.
Note: Always keep at least 6 adjustable jets open at all times.
11.12 Adjusting PowerPro™ MX2 Jets
Tilt PowerPro MX2 Jet nozzle to angle of choice as desired.
Rotate nozzle clockwise to reduce flow volume from jet or
rotate counterclockwise to increase flow volume.
Note: Always keep at least 6 adjustable jets open at all
times.

11.13 Adjusting RX Jets

Rotate the outside jet face clockwise to decrease or
shut off water flow. Turn counterclockwise to turn on or
increase water flow.
Note: Always keep at least 6 adjustable jets open at all times.

11.14 Waterfall Control

Turn waterfall control valve (pages 22-27) from side to side to
increase output, decrease output or turn off the waterfalls.
Note: When the waterfall is in the OFF position, some water
may still flow through. This is considered normal.

11.15 Air Controls

Certain jet systems have their own air control. Each control
introduces air into the water lines that supply that specific jet
group (pages 22-27). Simply press any air control button, Jacuzzi
logo side down, to open or press the opposite side to button to close. To
minimize heat loss, all air controls should be closed when the spa is not
in use.
Note: Certain jets may draw air even though they are closed. This is
considered normal.
Page 38