Winterizing - Jacuzzi J-585 Owner's Manual

5. Do not drag or use the flaps/skirt or the cover lock straps to remove
the cover.
6. Use only recommended cover lift systems.
7. Use only chemicals and cleaners recommended by Jacuzzi.
8. Remember to keep spa covered when not in use. Maintaining proper
water levels assures efficient operation and efficient electrical usage.
9. Do not expose your spa to the sun for extended periods of time as
UV rays can damage the interior surface.
10. Use caution when removing cover. Before removing cover, assure all
locks have been released to avoid lock breakage and or cover strap
damage.
13.8

Winterizing

Your Jacuzzi spa is designed to automatically protect itself against
freezing when operating properly. During periods of severe freezing
temperatures, you should check periodically to be certain that the
electrical supply to the spa has not been interrupted. In extreme, bitter
cold weather (less than 0°C) we recommend that the circulation pump is
set for 24-Hour operation (Section 12.2 Programming The Primary Filter
Cycle, page 41) and that auto-heating is selected (Section 12.1 Auto-
Heating, page 41) to protect against damage to the spa.
If you do not intend to use your spa, or if there is a prolonged power
outage during periods of severe freezing temperatures, it is important
that all water be removed from the spa and equipment to protect
against damage from freezing.
Expert winterization of your spa is highly recommended; contact
your authorized Jacuzzi dealer. In emergency situations, taking the
following steps can minimize damage:
CAUTION: TURN OFF POWER TO SPA.
1. Follow the directions on page 55 for draining the spa.
2. Turn the massage/diverter selector(s) into the middle combo position
to allow the water in the plumbing lines to drain, page 39.
3. Turn the waterfall valve to the open position to allow the water in the
plumbing lines to drain, page 38.
4. As the water level drops below the seats, use whatever means
necessary to get the water out of the recessed seating areas and
into the footwell, such as a wet/dry vacuum.
5. Open all the air controls and leave them open until you resume use
of the spa, page 38.
6. When the water level ceases to drop, use whatever means available
to remove any remaining water from the footwell, such as a wet/dry
vacuum.
7. Remove the equipment-side cabinet panels and locate the drain
plugs in the front of each pump (Figure 6.0a, page 14). Remove
these plugs to allow the water to drain out of the pumps and heater.
Page 58