Honeywell HRHT4041 Remote User Manual page 68

68 | Performance Series HQA Digital Video Recorder Remote User Guide
www.honeywell.com/security
Table 3-14
Configuration
PTZ Activation
Tour
Snapshot
Video Matrix
Voice Prompts
File Name
Show Message
Send Email
Buzzer
WEB - Motion Detection Configurations
Description
When PTZ activation is configured, the system can activate
PTZ operation when an alarm is detected.
1. Click Setup to open the PTZ Activation configuration
interface.
2. Select a preset, tour, or pattern from the drop-down menu.
3. Click Save.
Click to enable a tour to be triggered by an alarm. The system
supports 1/8-window tour. Refer to the User Guide for more
about tour interval setup. On the Display Settings tab, when
there are two tours enabled by default, you can configure the
system so an alarm triggers the system to enable the alarm
tours you configured here. If there is no alarm, then the system
uses the tour setup that was configured in the Display
interface.
Click to enable the Snapshot function. Channel snapshots
are taken according to the schedule you configure. Alarm
snapshots are taken when an alarm occurs.
Click to enable. When an alarm occurs, the SPOT OUT port video
(a 1-window tour) from the alarm activation channel selected in
the Record Channel.
Select to enable audio broadcast/voice prompts in response to
the event you selected in the drop-down list of event types.
Select a file for the voice prompt.
Click to enable a pop-up message on your local host PC
screen to let you know an alarm has occurred.
The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
 
Menu Setting Network
settings. Refer to the User Guide for more information.
Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.

Email to configure the email