Honeywell HRHT4041 Remote User Manual page 37

Table 3-2 Encoding Configurations
Setting
Resolution
Frame Rate
Bit Rate Type
Bit Rate
Reference Bit Rate
I Frame
Audio Enable
Audio Format
Audio Source
Watermark Enable
Description
The DVR system supports various resolutions, which you can
select from a dropdown list.
Note The selection is different for each DVR series. The HQA
DVRs can automatically detect a connected 720p or
1080p camera's configured resolution (as 720p or
1080p) But you must manually configure the resolution
(960H or below) for analog cameras, and 1080p HQA
cameras that are in SD mode.
PAL: 1 to 25 fps
NTSC: 1 to 30 fps
Select either CBR or VBR.
Main Stream: Select a bit rate to change the video quality.
The larger the bit rate, the better the video quality. We
recommend that you accept the default bit rate. The GUI also
displays the reference bit rate range and frame rate for the
selected resolution.
Sub Stream: In DBR, the bit rate is the maximum value. For
dynamic video, the DVR system will decrease the frame rate
or video quality to maintain the bit rate. The value is null for
VBR mode.
The recommended bit rate according to the resolution and
frame rate you have set.
Set the P-frame amount between two I-frames. Select from 1
or 2 seconds.
Enable or disable audio.
Set to G711a, PCM, or G711u (+G711µ).
Set to Local.
Allows you to verify that the video has not been tampered.
Select Watermark Bitstream, Watermark Mode, and
Watermark Character. The default watermark is
DigitalCCTV. The maximum text length is 85 characters. You
can use only letters, numbers, and an underline.
Configuration | 37
800-22740 - A - 02-2017