Cisco IW3702 Getting Started Manual page 34

Cisco IW3702 Access Point Getting Started Guide
Configuration
Entering en prompts you for a password, and then enters privileged exec mode. The default password is Cisco and
is case-sensitive.
When you finish configuring the access point:
6. Use a small flat-blade screwdriver to depress the tab on the RJ45 connector and disconnect the cable from the CON
port.
7. Replace the CON port cover.
8. Use a 0.5 in. (13 mm) socket wrench to torque the CON port cover to 6-7 ft-lbs (8.13-9.49 N-m).
1 Console port cover
Setting Access Point Settings
Use the system management pages in the web browser interface to set the access point settings. For information on
how to access the web browser interface, see
Use the system management pages to define configuration settings. A navigation bar appears on the left side of the
page; the configuration action buttons appear at the bottom. Use the navigation bar to access the various management
pages. Use the configuration action buttons to save or cancel setting changes.
Configuring the Access Point for Autonomous Operation
For information about configuring the access point for autonomous operation, see the
Autonomous Aironet Access
Connecting the Access Point to a Wireless LAN Controller
This section describes how to connect the access point to a wireless LAN controller. Because the configuration process
occurs on the controller, see the
Configuring the Access Point for Autonomous Operation, page
Points.
Cisco Wireless LAN Controller Configuration Guide for additional information.
34
34.
Cisco IOS Configuration Guide for