Remote Control - Pioneer VSX-1020-K Operating Instructions For The User

12 Additional information
Symptom
During playback of DVD-
Audio, the display shows
PCM.
The power turns off
automatically and some
indicator flashes, or some
indicator flashes and the
power does not turn on.

Remote control

Symptom
Cannot be remote controlled. • Set the remote control unit's remote control mode so that it matches the
Other components can't be
operated with the system
remote.
116
En
Remedy
• This will occur when playing DVD-Audio material over the HDMI connection.
This is not a malfunction.
• See the Power section (page 109).
Remedy
setting on the receiver (see Operating multiple receivers on page 78).
• Check whether the receiver's remote control mode is properly set (see
Remote Control Mode Setup on page 108).
• Try replacing the batteries in the remote control (see Loading the batteries on
page 8).
• Be sure to operate within 7 m and a 30º angle of the remote sensor on the
front panel (see Operating range of remote control unit on page 14).
• Check that there are no obstacles between the receiver and the remote
control.
• Make sure that there is no fluorescent or other strong light shining on to the
remote sensor.
• Check the connections of the CONTROL IN jacks (see Operating other Pioneer
components with this unit's sensor on page 38).
• If the battery ran down, the preset codes may have been cleared. Re-enter the
preset codes.
• The preset code may be incorrect. Redo the procedure for entering preset
codes.
• When commands from the remote control units of other devices are
registered using the learning function, in some cases they may not be learned
properly. In this case, register the commands again using the learning function
(see Programming signals from other remote controls on page 79). If they still do
not work, they may be in a special format that cannot be registered on this
receiver's remote control. Operate the device using another remote control.