Resetting The Input Assignment Of One Of The Input Function Buttons; Direct Function - Pioneer VSX-1020-K Operating Instructions For The User

Controlling the rest of your system
Resetting the input assignment
of one of the input function
buttons
This procedure resets the input assignment
preset at the remote control's input function
button, restoring the default.
1 Press and hold R.SETUP, then press "9"
for three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP.
2 Press and hold the input function button
corresponding to the command to be erased
for three seconds.
If the LED lights for one second, the erasing
has been successfully completed.

Direct function

• Default setting: On
You can use the direct function feature to
control one component using the remote
control while at the same time using your
receiver to play a different component. This
could let you, for example, use the remote
control to set up and listen to a CD on the
receiver, and then use the remote control to
rewind a tape in your VCR while you continue
to listen to your CD player.
When direct function is on, any component
you select (using the input function buttons)
will be selected by both the receiver and the
remote control. When you turn direct function
off, you can operate the remote control
without affecting the receiver.
1 Press and hold R.SETUP, then press "5"
for three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP.
2 Press the input function button for the
component you want to control.
3 Press "1" (On) or "0" (Off) to switch the
direct function mode.
If the LED lights for one second, the setting
has been successfully completed.
If the LED flashes three times, the setting has
failed.
4 Press R.SETUP to exit the setup.
09
81
En