Operating Range Of Remote Control Unit - Pioneer VSX-1020-K Operating Instructions For The User

02 Controls and displays
///, ENTER
7
Use the arrow buttons when setting up your
surround sound system (page 87) and the
Audio or Video options (page 69 or 72).
8 Receiver controls
Press
RECEIVER
PHASE CTRL – Switch on/off Phase Control
(page 63).
STATUS – Check selected receiver settings
(page 76).
PQLS – Select the PQLS setting (page 67).
S.RETRIEVER – Press to restore CD quality
sound to compressed audio sources
(page 70).
MIDNIGHT – Switches to Midnight or
Loudness listening (page 69).
SIGNAL SEL – Select an input signal
(page 62).
MCACC – Switch between MCACC presets
(page 62).
SLEEP – Use to put the receiver in sleep
mode and select the amount of time before
sleep (page 76).
CH LEVEL – Press repeatedly to select a
channel, then use / to adjust the level
(page 104).
A.ATT – Attenuates (lowers) the level of an
analog input signal to prevent distortion
(page 76).
DIMMER – Dims or brightens the display
(page 76).
9 LISTENING MODE controls
AUTO/ALC/DIRECT – Switches between
Auto Surround (page 58), Auto Level
Control mode and Stream Direct mode
(page 61).
STEREO – Switches between stereo
playback and Front Stage Surround
Advance modes (page 61).
STANDARD – Press for Standard decoding
and to switch between the various 2 Pro
Logic IIx and Neo:6 options (page 58).
14
En
first to access:
ADV SURR – Switch between the various
surround modes (page 60).
10 Remote control LED
Lights when a command is sent from the
remote control (page 78).
11 TV CTRL
Set the preset code of your TV's manufacturer
when controlling TV (page 79).
12 RECEIVER
Switches the remote to control the receiver
(used to select the white commands (SIGNAL
SEL, etc.)).
Switch to perform operations in the main zone.
Also use to set up surround sound.
13 MASTER VOLUME +/–
Set the listening volume.
14 MUTE
Mutes the sound or restores the sound if it has
been muted (adjusting the volume also
restores the sound).
Operating range of remote control
unit
The remote control may not work properly if:
• There are obstacles between the remote
control and the receiver's remote sensor.
• Direct sunlight or fluorescent light is
shining onto the remote sensor.
• The receiver is located near a device that is
emitting infrared rays.
• The receiver is operated simultaneously
with another infrared remote control unit.
30°
30°
7 m