Making An Audio Or A Video Recording - Pioneer VSX-1020-K Operating Instructions For The User

Using other functions
4 When Speaker System is set to ZONE 2,
use the MASTER VOLUME dial to adjust the
volume for the sub zone.
5 When you're finished, press MULTI-ZONE
CONTROL again to return to the main zone
controls.
You can also press MULTI-ZONE ON/OFF on
the front panel to switch off all output to the
2
sub zone.
MULTI-ZONE remote controls
Set the MULTI-ZONE operation switch to ZONE 2
to operate the corresponding zone.
The following table shows the possible MULTI-
ZONE remote controls:
Button What it does

Switches on/off power in the sub zone.
INPUT Use to select the input function in
SELECT the sub zone.
Input Use to select the input function
function directly (this may not work for some
buttons functions) in the sub zone.
MASTER Use to set the listening volume in the
a
VOLUME sub zone.
+/–
MUTE Mutes the sound or restores the
sound if it has been muted (adjusting
the volume also restores the sound).
a.You can only use this button when Speaker System
is set to ZONE 2.
Note
1 The volume levels of the main and sub zone are independent.
2 • You won't be able to switch the main zone off completely unless you've switched off the MULTI-ZONE control first.
• If you don't plan to use the MULTI-ZONE feature for a while, turn off the power in both the sub and main rooms so
that this receiver is in standby.
3 • The receiver's volume, Audio parameters (the tone controls, for example), and surround effects have no effect on
the recorded signal.
• Some digital sources are copy-protected, and can only be recorded in analog.
• Some video sources are copy-protected. These cannot be recorded.
1
a
Making an audio or a video
recording
You can make an audio or a video recording
from the built-in tuner, or from an audio or
video source connected to the receiver (such
3
as a CD player or TV).
Keep in mind you can't make a digital
recording from an analog source or vice-versa,
so make sure the components you are
recording to/from are hooked up in the same
way (see Connecting your equipment on
page 15 for more on connections).
Since the video converter is not available
when making recordings (from the video OUT
jacks) make sure to use the same type of video
cable for connecting your recorder as you
used to connect your video source (the one
you want to record) to this receiver. For
example, you must connect your recorder
using Component video if your source has also
been connected using Component video.
For more information about video
connections, see Connecting an HDD/DVD
recorder, BD recorder and other video sources
on page 29.
1 Select the source you want to record.
Use the input function buttons (or INPUT
SELECT).
2 Prepare the source you want to record.
Tune to the radio station, load the CD, video,
DVD etc.
3 Prepare the recorder.
Insert a blank tape, MD, video etc. into the
recording device and set the recording levels.
08
75
En