Ricoh Pro C5200s User Manual page 187

Problem
The print image is not
properly positioned on the
paper.
The print image is not
properly positioned on the
paper.
Fold
Problem
Wrinkling occurs when gate
fold, letter fold-in, or letter
fold-out is applied.
When you print Z-folded
paper, the machine
indicates that the output tray
is full even though the
amount of output paper on
the tray is less than the stack
capacity.
The multi-folding unit outputs
sheets with creased edges
when gate fold is applied.
The position of the fold is
incorrect when letter fold-in
is applied to a B5 JIS sheet.
Cause
The machine has not
detected the paper type
and/or width correctly.
The print position is not
aligned properly.
Cause
Wrinkling can occur if gate
fold, letter fold-in, or letter
fold-out is applied to B4 JIS
1
, A3 , 8 / " 14" ,
2
11" 17" , 12" 18" ,
8K , or larger sizes of
paper.
The Z-fold support tray is not
set.
The paper is curled.
Multi-sheet fold has been
specified when only one
sheet is being printed.
When You Have Problems Operating the Machine
Solution
Contact the machine administrator or
your service representative.
Contact the machine administrator or
your service representative.
Solution
When applying gate fold, letter fold-in,
or letter fold-out to paper larger than
A4, we recommend you enable image
reduction and use paper no larger
than A4 .
Set the Z-fold support tray for finisher
or multi-folding unit. For details about
how to add the Z-fold support tray, see
"Finishing", Copy/ Document Server.
Remove the paper, and then reload it
upside down. Alternatively, remove the
paper, and then reload it in the
opposite direction.
In [Finishing] on the initial copier
screen, under [Folding Unit], select
[Letter Fold-in]. Press [Change], and
then set "Multi-sheet Fold" to [Off]. For
details about how to specify the multi-
sheet fold function, see "Finishing",
Copy/Document Server.
185