Denon DVD-9000 Operating Lnstructions page 57

cursor buttons to select the MP3
file you want to play, then press the PLAY button or
ENTER button.
% Playback starts.
* The display can be switched between the single
elapsed time and the single remaining time by
pressing the DISPLAY button.
* Programmed playback is not possible with MP3
discs.
and
cursor buttons to reselect the desired MP3 file.
* To set a ~a~dQ~ ~1~~
In the p mode, press t
NDOM button.
Then press the PLAY button of ENTER button.
* lo set the repeat
The repeat mode changes each time the REPEAT
button is pressed.
FOLDER -+ TRACK REPEAT -+ FOLDER REPEAT
1'
~%i~n s~r@@~
rsor button to
select "ROOT" at the upper right of the screen,
then press the ENTER button.
The screen in step "1 reappears.
.L,,
Remote control ur lit
Main unii
Remote control unit
of The DVD-9000 is compatible with the "MPEG-1 Audio Layer 3" standards (sampling frequency of 32, 44.1 or 48 kHz). It is not
compatible with such other standards as "MPEG-2 Audio Layer 3", "MPEG-2.5 Audio Layer 3", MPI, MP2, etc.
@ It may not be possible to play some CD-RIRW discs due to disc properties, dirt, warping, etc.
* The digital signals output when playing MP3 files are MP3 signals converted into PCM, regardless of whether the audio output
presetting is set to "normal" or "PCM". The signals are output with the same sampling frequency as that of the music source.
e In general, the higher an MP3 file's bit rate, the better the sound quality. On the DVD-9000, we recommend using MP3 files
recorded with bit rates of 128 kbps or greater.
0 MP3 files may not be played in the expected order, since the writing software may change the position of the folders and the
order of the files when writing them on the CD-R/RW.
* Programmed playback are not possible with MP3 discs.
* When writing MP3 files on CD-R/RW discs, select "IS09660 level 1" as the writing software format. This may not be possible
with some types of writing software. For details, refer to the writing software's usage instructions.
* With the DVD-9000 it is possible to display folder names and file names on the screen like titles. The DVD-9000 can display up
to 8 characters, consisting of numbers, capital letters, and the "_" (underscore) mark.
* If recorded in a format other than "IS09660 level I", normal display and playback may not be possible. In addition, folder and file
names including other symbols will not be displayed properly.
* Be sure to add the extension ".MP3" to MP3 files. Files cannot be played if they have any extension other than ".MP3" or if they
have no extension. (with Macintosh computers, MP3 files can be played,,by adding the extension ".MP3" after the file name
consisting of up to 8 capital or numbers and recording the files on the CD-R/RW.)
@ Do not apply stickers, tape, etc., to either the label side or the signal side of CD-R/RW discs. If adhesive gets on the surface of
a disc, the disc may get stuck inside the DVD-9000 and be impossible to eject.
+I The DVD-9000 is not compatible with packet write software.
@ The DVD-9000 is not compatible with IDS-Tag.
e The DVD-9000 is not compatible with play lists.
e Do not play CD-R/RW discs containing any files other than music CD files (in CDA format), MP3 and JPEG files. Doing
SO
may
result in malfunction or damage, depending on the type of file.