Denon DVD-9000 Operating Lnstructions page 16

High quality digital sound with reduced digital signal transfer loss can be enjoyed by connecting a separately sold Denon Link compatible
AU amplifier.
DVD-9000
To power outlet
El
Center speaker
Front speaker (right)
Subwoofer
Surround speaker (left)
Surround speaker (right)
e With Denon Link, digital transfer is only possible for discs that are not copyright-protected.
@ When playing linear PCM or packed PCM DVDs that are not copyright-protected, digital transfer is possible at up to 24bits/Z-
channels for 192/l 76.4 kHz or 24-hits/6-channels for 96 kHz by using Denon Link connections.
* When playing copyright-protected linear PCM or packed PCM DVDs, in consideration of copyrights, linear PCM signals are not
output from the DENON LINK terminal for sources exceeding 48 kHz/lG bits, so also make analog connections (see page 141.
"PROTECTION" is displayed on the DVD-9000's display when copyright-protected DVDs are played.
e To output signals from the DENON LINK terminal when playing DVDs that are not copyright-protected, set "DIGITAL OUTPUT"
at "PURE DIRECT MODE" to "OFF". (See page 54.)
(If set to "ON", for some discs signals below 96 kHz/'2 channels will be output from the DENON LINK and analog audio output
terminals,)
e Set "LPCM (44.1 kHz148 kHz)" under "AUDIO SETUP" at "SETUP" to "OFF". (See page 32.1
(If set to "ON", analog audio signals converted to 48 kHz will be output for linear PCM or packed PCM sources.)
@ To output the bitstream signals of Dolby Digital, DTS or other sources from the DENON LINK terminals, set "DIGITAL OUTPUT"
at "PURE DIRECT MODE" to "ON". (See page 54.1