Fax Error Code - Ricoh RN-MF2 Field Service Manual

3. Appendix: Troubleshooting Guide
Message
Unsupported
Device
Please Remove
Unsupported
Device
Press Clear key
Unsupported USB
Hub Please
Remove
USB Disconnected
Press Clear key
USB Memory
Overflow Press
Clear key
Write Protect Press
Clear key

Fax Error Code

This section describes the dial, transmission (TX), and reception (RX) error codes that are printed on the
TX Report/Activity Report.
Error codes consist of six hexadecimal digits (0-5).
Digit 5 indicates Fax/Internet Fax and TX/RX.
24
Causes
The Scan to USB function failed
because a USB device other than
a USB flash disk or a USB flash
disk with an unsupported file
system was used.
The Scan to USB function failed
because a USB device other than
a USB flash disk or a USB flash
disk with an unsupported file
system was used.
The Scan to USB function failed
because a USB device other than
a USB flash disk or a USB flash
disk with an unsupported file
system was used.
The Scan to USB function failed
because the USB flash disk was
removed before the operation
could be completed.
The Scan to USB function failed
because there was not enough
memory on the USB flash disk.
The Scan to USB function failed
because the machine could not
access the USB flash disk
properly.
Solutions
Use a USB flash disk that is compatible
with the Scan to USB function.
Use a USB flash disk that is compatible
with the Scan to USB function.
Use a USB flash disk that is compatible
with the Scan to USB function.
Check that the USB flash disk is securely
inserted in the machine. Do not pull out the
USB flash disk until "Ready" appears on
the display.
Use a USB flash disk with enough memory.
Use a USB flash disk that is not password-
or write-protected.