Remote Wipe Device; Add Users To Cisco Unified Communications Manager - Cisco DX650 Administration Manual

Add Users to Cisco Unified Communications Manager

Remote Wipe Device

Procedure
Step 1
In the Phone Configuration window for the device, select Wipe.
Step 2 Select Wipe to accept the Wipe confirmation message.
You can view the Wipe status in the Device Lock/Wipe Status section of the Phone Configuration window
for the device.
Add Users to Cisco Unified Communications Manager
Adding users to Cisco Unified Communications Manager allows you to display and maintain information
about users and allows each user to perform these tasks:
• Set up speed-dial and call-forwarding numbers
• Subscribe to services that are accessible from Cisco Desktop Collaboration Experience
You can add users to Cisco Unified Communications Manager individually or in batches. To add users
individually, follow these steps.
Procedure
Step 1 From Cisco Unified Communications Manager Administration, choose User Management > End User.
Step 2
Click Add New.
Step 3 In the User Information window, enter required information.
Step 4 In the Device Information window, select the device that you want to associate the user with.
Step 5
Assign the user Cisco Unified Communications Manager Administration End User Permissions.
Step 6 Click Save and Apply Config.
For more information, go to the
Administration Guide.
To add users in batches, use the Bulk Administration Tool. This method also allows you to set an identical
default password for all users.
For more information, go to the
Administration Guide.
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
150
End User Configuration chapter in the Cisco Unified Communications Manager
Bulk Administration chapter in theCisco Unified Communications Manager