Ipv4 Configuration Menu - Cisco DX650 Administration Manual

Wireless and Networks Settings Menu

IPv4 Configuration Menu

The IPv4 configuration menu is a submenu of the Ethernet Settings menu. To access the IPv4 menu, select
IPv4 configuration on the Ethernet settings menu. The following table describes the IPv4 Configuration
menu options and, where applicable, explains how to change them.
Table 26: IPv4 Configuration Menu
Option
Use Static IP
IP address
Gateway
Netmask
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
108
Description
Allows you to manually set IP
address if DHCP is not used.
Internet Protocol (IP) address of
Cisco Desktop Collaboration
Experience.
Gateway used by Cisco Desktop
Collaboration Experience.
Netmask used by Cisco Desktop
Collaboration Experience.
To change
Tap to enable or disable option.
1 Tap Use static IP to enable.
2 Select IP address.
3 Enter IP address.
4 Tap OK.
1 Tap Use static IP to enable.
2 Select Gateway.
3 Enter Gateway name.
4 Tap OK.
1 Tap Use static IP to enable.
2 Select Netmask and then
enter Netmask name.
3 Tap OK.