Taking The Device Into Operation - VeriFone H5000 Installation Instructions Manual

6

Taking the device into operation

Prerequisites for taking the
device into operation
Start taking-into-operation
procedure
Select language
Enter password
Enter Terminal ID
Select RDT module
Installation Instructions H5000
Before you can conduct any transactions with the device,
you need to take the device into operation.
The prerequisites for the taking into operation are:
• The telephone cable (ISND or analogue telephone) /
network cable (LAN) is plugged in.
• A valid Terminal ID is available.
i You can get the Terminal ID (TID) from your service
provider. The Terminal ID (TID) is an 8-digit number.
► Connect the mains lead with the socket.
i As soon as the device is supplied with power for the first
time, the taking-into-operation procedure will start.
► Select the language.
► Enter the merchant password.
i The basic setting of the password is 000000.
► Confirm the entry.
► Enter the Terminal ID (TID).
► Confirm the entry.
► Enter the Terminal ID again (TID).
► Confirm the entry.
► Select RDT module.
The further procedure of the taking-into-operation is
i
dependent on the RDT module (LAN / ISDN / Modem):
– LAN module, see chapter
connection on page 42
– ISDN module, see chapter
Modem connection on page 44
– Modem, see chapter
connection on page 44
Taking the device into operation
6.3.1 Setting up the LAN
6.3.2 Setting up ISDN /
6.3.2 Setting up ISDN / Modem
41