VeriFone H5000 Installation Instructions Manual page 42

Taking the device into operation
6.3.1 Setting up the LAN connection
Assign IP address via DHCP
server
Enter IP address manually
42
After selecting the RDT module LAN the device establishes
the LAN connection itself.
i Only when an automatic setting up is not possible with
the parameters pre-set in the device, you need to
undertake the following settings:
► Select the corresponding setting:
– Yes: there is a DHCP server in your network which
assigns an IP address to the device (continue with
"assign IP address via DHCP server").
– No: the IP address is entered manually (continue with
"enter IP address manually").
The IP settings are determined automatically.
Further parameters pre-set by your service provider are
enquired.
► Confirm the pre-set parameters.
The device carries out the taking-into-operation
automatically.
i One or two-digit values must be entered with leading
zeros.
► Enter the following parameters one after the other:
– IP address of terminal
– Subnet mask of the terminal
– IP address of gateway of terminal
– IP address of DNS of terminal
i Please contact your network administrator if you have
questions about the parameters to be entered.
► Confirm each entry.
Further parameters pre-set by your service provider are
queried.
► Confirm the pre-set parameters.
Installation Instructions H5000